A B C D E F G H I L M N O P R S T U V W

P

paintComponent(Graphics) - Method in class edu.nau.cs.scu.DrawFrontViewAntenna

Handles the setup and display of this antenna representation.

paintComponent(Graphics) - Method in class edu.nau.cs.scu.DrawTopViewAntenna

Handles the setup and display of this antenna representation.

parityBits() - Method in enum edu.nau.cs.scu.SerialConfiguration

Retrieves the numerical constant specified in SerialPort which signifies the number of parity bits

passPowerUp() - Method in class edu.nau.cs.scu.PMCentralInterface

Instruct the servo controller to pass the power-up sequence.

PMCentralInterface - Class in edu.nau.cs.scu

This class provides an interface for the physics simulation of the gimbal device.

PORT_ANTENNA_SELECT - Static variable in class edu.nau.cs.scu.Command

The byte representing a port antenna select command.

portAntennaSelected - Variable in class edu.nau.cs.scu.Status

True if the port antenna is selected, false if the starboard antenna is selected.

POSITION_MODE - Static variable in class edu.nau.cs.scu.Command

The byte representing a position mode command.

positionMode(double, double) - Method in class edu.nau.cs.scu.PMCentralInterface

Enable "Position Mode", which will move the gimbal to a specified position at the default rate for the device.

positionMode(double, double) - Method in class edu.nau.cs.scu.testcode.MEUSimulatorGUI

Issues a "Position Mode" command over the serial communications to a servo controller unit.

positiveSoftStopPositionAzimuth - Variable in class edu.nau.cs.scu.Status

The location of the azimuth positive soft stop in radians

positiveSoftStopPositionElevation - Variable in class edu.nau.cs.scu.Status

The location of the elevation postitive soft stop in radians

posSoftStopAngle - Variable in class edu.nau.cs.scu.DrawFrontViewAntenna

The currently set positive soft stop angle, in degrees.

posSoftStopAngle - Variable in class edu.nau.cs.scu.DrawTopViewAntenna

The currently set positive soft stop angle, in degrees.

powerUpPassed - Variable in class edu.nau.cs.scu.Status

True if the BIT passed the last time it was run, false if the BIT failed the last time it was run

powerUpStartTime - Variable in class edu.nau.cs.scu.PMCentralInterface

propertyString() - Method in enum edu.nau.cs.scu.SerialConfiguration

Returns a specially formatted string which uniquely identifies one of the SerialConfiguration enum constants.